Honeywell LYNX Touch Series Installation And Setup Manual

Also see for LYNX Touch Series: User guide Guide Installation and setup guide Programming guide Quick installation guide

Contents

Honeywell LYNX Touch Series Installation And Setup Manual Manual pdf 28 page image

LYNX Touch Installation and Setup Guide- 28 -Programming the ControlProgram KeysThe following system options are programmed in this sectionOption FunctionKey Type Select the specific type of key being entered or enrolledUser Associates the Key with a specific UserSerial Number Manually enter key serial number or enroll via RF transmissionZone Manually enter key zone number (between 49 and 64) or enroll via RF transmissionButton Key * - Zn * Associate the selected button with a specific function* Key number and Zn number are dependant upon the Key Type selected.Note: If applicable, preprogrammed defaults for the LYNX Touch Control are shown on the screen unless otherwise noted.SCREEN ACTIONKeys1. Select “Keys”The System displays the following options:Edit Add New Delete2. Select “Add New”.3. The following options are displayed (dependant upon the “Key Type” selected):Key Type UserSerial Number ZoneButton Key 1 – Zn 49 Button Key 2 – Zn 50Button Key 3 – Zn 51 Button Key 4 – Zn 52Button Key 5 – Zn 53 Button Key 6 – Zn 54Button Key 7 – Zn 55 Button Key 8 – Zn 564. Select an option to display the next programming field.Key Type4 Button keyKey TypeSelect “Key Type”. The system scrolls between the following:1 Button key 6 Button key2 Button key 8 Button key4 Button keyUser User4. Select “User” then select from the following options (or the list of Users that have beenprogrammed):Master BabysitterDuress User 3User 4 User 5User 6 User 7Use the down T arrow to scroll to the next page. The system displays options for User 8through 14.Note: The Key must be associated with a specific User/User Code in order for it to operate.Refer to the LYNX Touch User Guide for additional Information regarding User Codes.Serial Number0Serial NumberWhen “Serial Number” has been selected “Enter Serial Number or Activate” is displayed. Thetransmitter serial number and loop number can be enrolled via RF transmission OR manually.Enroll via RF Learning To enroll the device using RF Learning mode three transmissions(open/close) of the device will be required. The initial transmission activates the RF Learningmode. A second transmission enrolls the serial number and the system beeps two times anddisplays “Activate Sensor Again To Confirm”. A third transmission will confirm the serialnumber. The system beeps three times and returns to the Zone programming Screen.Enroll ManuallyEnter the 7-digit serial number printed on the transmitter using the displayed keypad andselect “Done”. The system beeps one time and returns to the Zone programming Screen.Zone49ZoneThe system displays the next available key Zone number. Select “Zone” to manually enter aspecific Zone Number on the displayed keypad (49-64). If the desired Zone Number is notavailable, the system returns to the previous screen.Select ”Done”. The system returns to the previous screen. Repeat the previous step to enteranother Zone Number.WWW.DIYALARMFORUM.COM