219www.gateway.comLED information■ Make sure that the last device on the SCSI cable is correctly terminated. For moreinformation about SCSI device configurations, see the device’s documentation.■ Use a different SCSI cable.The master boot record is corrupted■ In a Windows network operating system, repair the master boot record using FDISK.To repair the master boot record:■ At a DOS command prompt, type fdisk/mbr, then press E NTER.InternetYou cannot connect to the Internet■ Make sure that your account with your Internet Service Provider (ISP) is set upcorrectly. Contact your ISP technical support for help.KeyboardLiquid has been spilled into the keyboard■ If you spilled liquid in the keyboard, turn off your server and unplug the keyboard.Clean the keyboard and turn it upside down to drain it. Let the keyboard dry beforeusing it again. If the keyboard does not work after it dries, you may need to replace it.This type of damage is not covered by your server’s warranty.MemoryMemory errors were detected during server start up■ Open your server and make sure that the memory modules are installed correctly. Formore information, see “Installing and removing DIMMs” on page 91.■ A memory module may be defective. Check the LEDs on all of the memory boardsto make sure no fault LEDs are on. Replace the faulty memory.
