161www.gateway.comUpdating the BIOSResetting BIOS passwordsTo reset BIOS password(s), you must either reset and clear all BIOS settings, or use thePassword Clear jumper (J4A1). To clear BIOS settings, follow the instructions in “Resettingthe BIOS” on page 158.To clear the BIOS passwords using the password clear jumper:1 Turn off the server, then disconnect the power cords and all other cables connectedto the server.2 Follow the instructions in “Opening the server case” on page 66.3 Remove the jumper across pins 1-2 of header J4A1, then place the jumper acrosspins 2-3.4 Follow the instructions in “Closing the server case” on page 72.5 Reconnect the power cords and turn on the server. The BIOS password(s) is cleared.6 Turn off the server, then disconnect the power cords and all other cables connectedto the server.Caution Moving the jumper while the power is on can damage your server.Always turn off the server and unplug the power cords and all othercables before changing the jumper.J8C1 J8C2 J8C3FRB3DisableBMCResetFWHID
