190 www.gateway.comChapter 6: Configuring your RAID solutionsTo check the rebuild rate:■ Select the correct adapter from the Adapter box, then select Rebuild Rate from theAdapter menu. If there is more than one adapter in the system, click each adapter andcheck the rebuild rate. The rebuild rate is not affected when you clear theconfiguration.To Exit the Web Console:■ Select Exit from the Configuration menu to quit the Web Console.Reclaiming hot spare disksTo reclaim hot spare disks:■ Select the drive and select Remove Hot Spare from the right pane. The Web Consolechanges the state of the selected drives to the READY state.Reconfiguring existing arraysThis section provides instructions for adding and removing physical drives from existingarrays.Adding a physical drive to an existing arrayTo add a physical drive to an array:1 Go to the Config View screen.2 Highlight the logical drive and select properties from the left pane. Select the driveto add from the Add Physical Drive pane.
