159www.gateway.comUpdating the BIOS3 Remove the jumper across pins 1-2 of jumper J4A3, then place the jumper acrosspins 2-3.4 Follow the instructions in “Closing the server case” on page 72.5 Insert a DOS-bootable CD (SCCD or current SUP CD) into the CD drive or aDOS-bootable USB disk-on-key containing a valid BIOS image into a USB port. For moreinformation on creating a current SUP CD, see “Creating a DOS-bootable SystemUpdate Package (SUP) CD” on page 42.6 Reconnect the power cords and turn on the server. The BIOS recovery is initiated.While the BIOS is being recovered, the monitor displays a blue screen and the serverwill beep continually. The process is complete when the server stops beeping.7 Remove the bootable USB disk-on-key or CD.8 Turn off the server, then disconnect the power cords and all other cables connectedto the server.9 Follow the instructions in “Opening the server case” on page 66.10 Place the jumper back onto pins 1-2.Important The new flash BIOS image will not fit on a diskette.J8C1 J8C2 J8C3FRB3DisableBMCResetFWHID
