Garmin GPS 400W Installation Manual

Also see for GNC 420AW: Maintenance manual Pilot's guide addendum Quick reference guide Pilot's Guide & Reference Pilot's Guide & Reference

Contents

Garmin GPS 400W Installation Manual Manual pdf 50 page image

Page 3-6 GNS 400W Series Installation ManualRev. G 190-00356-083.8 Cable InstallationRoute the coaxial cable to the rack location keeping in mind the recommendations of Section 2.6.Terminate the coax with the coax connectors following the manufacturer instructions. Secure the cable inaccordance with good aviation practice.The card-edge connector may be used to terminate shield grounds to the 400W Series back plate.Feed wires through the connector backshells before insertion into the 25-, 44-, and 78-pin connectors.Contacts for the 25-, 44-, and 78-pin connectors must be crimped onto the individual wires of the aircraftwiring harness. The following table lists contact part numbers (for reference). See Table 3-3 forrecommended crimp tools.Table 3-4. Pin Contact Part Numbers78-pinConnector(P4001)44-pinConnector(P4006)25-pin Connector (P4002) Shield GroundConnectorConnectorTypeHigh Density PinContact Standard Density Socket Contact .1-inch Pitch Card-EdgeWire Gauge 22-24 AWG 18 AWG 20-24 AWG 20-24 AWGGarmin P/N 336-00021-00 336-00023-00 336-00022-00 336-00029-00Military P/N M39029/58-360 N/A M39029/63-368 N/AAMP 204370-2 N/A 205090-1 583853-4Positronic M39029/58-360 FC6018D M39029/63-368 N/AITT Cannon 030-2042-000 See Note 2 031-1007-042 N/ANotes:1. Non-Garmin part numbers shown are not maintained by Garmin and consequently are subject tochange without notice.2. Alternate contacts for 18 AWG wire: As an alternative to the Positronic contacts listed (andprovided in the installation kit), the installer may use contacts made by ITT Cannon underP/N 031-1007-001. These contacts require the use of a different crimp tool positioner thanshown in the table, with the part numbers as follows: Daniels P/N K250, Astro P/N 616245, orITT Cannon P/N 980-0005-722.3. For the card-edge connector pin contacts, use AMP part number 90272-1 or equivalentcrimping tool.To prevent a possible short across the pins in the wiring harness, Teflon shrink tubing P/N 312-00005-05,provided in Connector Kit 011-00351-00 (P4002) covers the oversized power and ground pin contactsP/N 336-00023-00 (pins 11, 12, 21, 22) that protrude from the back of the connector shell. Beforecrimping the pins onto the wire:1. Cut the tubing (312-00005-05) into 4 equal lengths.2. Slide a short piece of the tubing over the wire.3. Strip the wire and crimp the pin (336-00023-00) onto the wire.4. Insert the pin into the connector shell.5. Slide the tubing over the exposed portion of the pin and shrink using a heat gun.