GE JCB560 Owner's Manual

Also see for JCB560: Owner's manual

GE JCB560 Owner's Manual Manual pdf 16 page image

CLOCKHORLOGEMake sure the clock is set to thecorrect time of day.T IMERM INUTERIEThe Timer is a minute timer only.The Timer does not control ovenoperations. The maximum setting onthe Timer is 9 hoursand 59 minutes.Using the clock, timer and convenience outlet.To Set the ClockThe clock must be set to the correct timeof day for the automatic oven timingfunctions to work properly. The time ofday cannot be changed during a timedbaking or self-cleaning cycle.Touch theCLOCKpad.Touch the numberpads.Touch theSTART pad.To Set the TimerTouch theTIMER pad.Touch the number pads until theamount of time you want showsin the display. For example, to set2 hours and 45 minutes, touch2, 4and5 in that order. If you make amistake, touch theTIMER pad andbegin again.Touch theSTART pad.After touching theSTARTpad,SETdisappears;this tells you the time is counting down, althoughthe display does not change until one minute haspassed. Seconds will not be shown in the displayuntil the last minute is counting down.When the Timer reaches:00, thecontrol will beep 3 times followed byone beep every 6 seconds until theTIMER pad is touched.The 6-second tone can be canceled by followingthe steps in the Special features of your ovencontrol section under Tones at the End of aTimed Cycle.To Reset the TimerIf the display is still showing the timeremaining, you may change it bytouching theTIMER pad, then touchthe number pads until the time youwant appears in the display.If the remaining time is not in the display(clock, delay start or cooking time are inthe display), recall the remaining timeby touching theTIMER pad and thentouching the number pads to enter thenew time you want.To Cancel theTimerTouch theTIMER pad twice.Convenience Outlet (on some models)The 120V convenience outlet located onthe top of the backguard may be used toplug in small electrical appliances.When using the outlet, be sure that theelectrical cord does not rest on or near asurface unit. If the surface unit is turnedon, the cord will be damaged.To reset the circuit breaker, press theswitch located near the outlet on top ofthe backguard.Operating Instructions16Safety InstructionsCare and CleaningTroubleshooting TipsConsumer Support