4-26 CARESCAPE Monitor B850 2040384-004D5. Select Save.The changes will take effect immediately.ControlAfter the server has been configured for remote serviceability, the remote serviceagent must be enabled for use.NOTEBe sure that you have read and understood all associated InSite 2.0documentation, including “Remote service” on page 4-25. By enabling RemoteService, you are enabling supported Remote Service features for this device.1. If you have not already done so, “Log into Webmin” on page 4-4 and select theConfiguration tab.2. On the Configuration tab, select Remote Service.3. On the Sub-Modules for Remote Service menu, select Control.4. Under Remote Service Control on the Remote Service Control window, enableor disable the Service Agent by selecting Enable or Disable.5. Select Save.The changes will take effect immediately.Enterprise URL If required, designate the addressof the GE backoffice serversrequired to communicate with theRemote Service Agent. This address should neverbe changed unless explicitinstructions are given to doso.Enterprise TunnelURLIf required, designate the addressof the GE backoffice serversrequired to communicate with thetunneling agent.Protocol Identifies the protocol used tocommunicate with the enterpriseservers.This field is read-only andcannot be changed.Remote Service ConfigurationItem Description Comments
