1-2 CARESCAPE Monitor B850 2040384-004DManual informationRevision historyEach page of the document has the document part number and revision at the bottomof the page. The revision changes whenever the document is updated.Intended useThe CARESCAPE™ Monitor B850 is a multi-parameter high acuity patient monitorintended for use in multiple areas within a professional healthcare facility.The CARESCAPE Monitor B850 is intended for use on adult, pediatric, and neonatalpatients and on one patient at a time.The CARESCAPE Monitor B850 system is indicated for monitoring ofHemodynamic (including ECG, ST Segment, Arrhythmia Detection, ECG DiagnosticAnalysis and Measurement, Invasive Pressure, Noninvasive Blood Pressure, PulseOximetry, Cardiac Output, Temperature, Impedance Respiration and SvO2 (MixedVenous Oxygen Saturation)), Airway Gases (Fi/Et CO2, O2, N2O and AnestheticAgent), Spirometry, Gas Exchange (O2 Consumption (VO2), CO2 production(VCO2), energy expenditure (EE), and respiratory quotient (RQ)) andneurophysiological (including electroencephalography (EEG), Entropy, BispectralIndex (BIS) and Neuromuscular Transmission (NMT) Monitoring) status.The CARESCAPE Monitor B850 provides alarms, trends, snapshots and events, andcalculations and can be connected to displays, printers and recording devices. TheCARESCAPE Monitor B850 can be a stand-alone monitor or interfaced to otherdevices. It can also be connected to other monitors for bed to bed viewing and to datamanagement software devices via a network.The CARESCAPE Monitor B850 is intended for use under the direct supervision of alicensed healthcare practitioner, or by personnel trained in proper use of theequipment in a professional healthcare facility. In addition to the healthcarepractitioner, the CARESCAPE Monitor B850 is designed to provide configurationand troubleshooting capabilities to qualified service personnel.The CARESCAPE Monitor B850 is not intended for use during MRI.Revision CommentA Initial releaseB Updated the CARESCAPE Monitor B850 Addendum for DeviceCompatibility.C Configure Time Zone added in Time configuration and Module voltage lowcase added in error messages. Updated the “Replace the processor board”and “Replaceable parts” chapters.D Hostname configuration chapter added, Network configuration and Citrixchapters updated.