7-8 C70 Capacitor Bank Protection and Control System GE Multilin7.1 COMMANDS 7 COMMANDS AND TARGETS77.1.7 SECURITYiPATH: COMMANDS SECURITYWith the CyberSentry option, this setting is available to enable or disable the following commands:• Administrator Logoff: Selecting ‘Yes’ allows the Supervisor to forcefully logoff an administrator session.• Engineer Logoff: Selecting ‘Yes’ allows the Supervisor to forcefully logoff an engineer session.• Operator Logoff: Selecting ‘Yes’ allows the Supervisor to forcefully logoff an operator session.• Clear Security Data: Selecting ‘Yes’ allows the Supervisor to forcefully clear all the security logs and clears all theoperands associated with the self-tests.Targets7.1.8 TARGETS MENUEach C70 element with a TARGET setting has a target message that when activated by its element is displayed insequence with any other currently active target messages in the TARGETS menu. In the example shown, the Phase TOC4and Digital Element 48 target settings are active and so have their targets displayed. The down arrow below the two ele-ments indicates that there can be other active elements beyond these two.For more information, see the description of target messages in the next section, and the Introduction to Elements sectionin the Settings chapter for instructions on TARGET setting.When no targets are active, the display reads NO TARGETS.7.1.9 TARGET MESSAGESWhen there are no active targets, the first target to become active will cause the display to immediately default to that mes-sage. If there are active targets and the user is navigating through other messages, and when the default message timertimes out (i.e. the keypad has not been used for a determined period of time), the display will again default back to the tar-get message. SECURITYADMINISTRATORLOGOFF: NoRange: Yes, NoDefault: NoENGINEERLOGOFF: NoRange: Yes, NoDefault: NoOPERATORLOGOFF: NoRange: Yes, NoDefault: NoCLEAR SECURITY DATA: Range: Yes, NoDefault: NoTARGETSMESSAGE PHASE TOC4OP: A B -Displayed only if targets for this element are active.Example shown.MESSAGE DIGITAL ELEMENT 48:LATCHEDDisplayed only if targets for this element are active.Example shown.MESSAGE
