You can select the microphone sound to match the recording situation.* Only available when audio AUDIO DUB. has been set to MIC. IN.1. Open the VCR SET UP submenu and select MIC.2. Select the setting and close the menu.NORMAL: General recording.VOICE: When recording a person’s voice.W. SCREEN: In windy places such as the beach or near buildings. Note that low sound may bereduced together with the wind noise.54ERecordingAudio RecordingThe XM2 can record sound in two audio modes:• 16-bit (48 kHz, 2 channel) for the highest sound quality• 12-bit (32 kHz, 2 from 4 channels) for recording on two channels (stereo 1), leaving two channels(stereo 2) free for you to add new sound at a later date.* Only available when AUDIO DUB. has been set to MIC. IN.1. To switch the mode, open the VCR SET UP submenu and select AUDIO MODE.2. Select a mode and close the menu.• The name of the selected mode is displayed for 4 seconds.Note:• For audio output details and how to play back a tape with added sound on stereo 2, see p. 109.+ , + *PLAY(VCR)TAPECAMERATAPEAUDIO MODE•• 16bitVCR SET UP( 18)+ , + *PLAY(VCR)TAPECAMERATAPESelecting the Audio ModeSelecting the Built-in Microphone SoundMIC••••••••••NORMALVCR SET UP( 18)
