COPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CHAPTER 11 TROUBLESHOOTING11-17C. Image Formation System1. Grid Wire of the Primary Charging Assembly1) Loosen the two mounting screws used to fix the left /right shielding plate in place.2) Loosen the three mounting screws used to fix the motor unit in place at the front.Figure 11-2183) Loosen the mounting screw, and move the assembly in the direction indicated inFigure 11-219; then, fix it in place temporarily.Figure 11-2194) Free a length of charging wire (about 5 cm) from the charging wire reel (0.1mm dia.);then, form a loop at its end (2mm dia.)Reference:To form a loop, wind the charging wire around a hex key three to four times, andtwist the charging wire.5) Cut the twisted charging wire (excess) with a nipper.ScrewScrewsDownload service manual and resetter printer at http://printer1.blogspot.com
