K. Developing AssemblyThe machine’s developing assembly is not equipped with a developing cylinderprotection cover, requiring you to take care whenever you have removed thedeveloping assembly.If the developing assembly is not set inside the copier, be sure not to install thedeveloping assembly locking assembly. Otherwise, the toner collecting in the paththrough which toner is fed from the hopper to the developing assembly can start topour out because of the vibrations caused by inspection/repair work.1. Removing the Developing Assembly from the Copier1) Open the multifeeder door; then, remove the mounting screw, and remove the doorstopper tape.2) Remove the mounting screw q, and push the developing assembly lockingassembly w in the direction of the arrow to remove.Figure 4-3353) Disconnect the connector e, and slide out the developing assembly r from thecopier.Figure 4-336e rqwCOPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CHAPTER 4 IMAGE FORMATION SYSTEM4-60Caution:Download service manual and resetter printer at http://printer1.blogspot.com
