6) Hook the loop on the stud A shown in Figure 11-220.Figure 11-2207) After routing the wire for 31 runs, lead it through section B, give it a 1/2 turn, lead itbetween washer and motor unit, wind it once around the mounting screw clockwise,and fix it in place with the mounting screw.8) Cut the excess charging wire with a nipper.9) Tighten the mounting screw loosened in step 8).Take care to avoid deformation (slack) of the charging assembly. Try to tighten themounting screw (front) on the shielding plate (left, right) earlier.Stud AScrew BCOPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CHAPTER 11 TROUBLESHOOTING11-18Download service manual and resetter printer at http://printer1.blogspot.com
