Problems Sending FaxesCannot Send a FaxCannot Perform Sequential Broadcasting by Redialing, or Cannot Dial Using the Numeric ButtonsErrors Often Occur When You Send a FaxCannot Send a FaxCheck1 Is the power turned on?• You cannot send faxes if the power is turned off. Press the ON button to turn the power on.• If you unplugged the power cord without turning off the power (the POWER lamp is lit), reconnecting itturns on the power automatically.• If you unplugged the power cord after pressing the ON button to turn off the power (the POWER lamp isoff), reconnect it, then press the ON button to turn on the power.• If the power was turned off due to power failure, etc., the power is automatically turned on when thepower failure is resolved.Important• Confirm that the POWER lamp is off before unplugging the power cord, then unplug the power cord.If a power failure occurs or you unplug the power cord, all faxes stored in the machine's memory aredeleted.For details on how to unplug the power cord, refer to Notice for Unplugging the Power Cord.Note• If the faxes stored in the machine's memory are deleted by a power failure or unplugging the power cord,the list of the faxes deleted from the machine's memory (MEMORY CLEAR REPORT) will be printedafter turning the machine on.For details, see Summary of Reports and Lists.Check2 Is the document being sent from memory or the fax being received intomemory?When the message for the transmission/reception is displayed on the LCD, a fax is being sent from/receivedinto machine's memory. Wait until the transmission/reception is complete.Check3 Is the machine's memory full?Delete contents in memory, then send a fax again.Document Stored in Machine's MemoryCheck4 Is the telephone line type set correctly?Check the telephone line type setting and change it as necessary.Setting the Telephone Line TypeCheck5 Is On-hook setting set to Disable?558
