The Machine Cannot Be Detected in the Wireless LANCheck1 Make sure that the machine is turned on.Check2 Is Change LAN in LAN settings under Device settings set to Disable LAN?Check3 When the machine is connected to the computer temporarily using a USBcable, make sure that the USB cable is connected properly.When you set up the wireless LAN connection or change the wireless LAN settings using IJ Network Toolthrough USB connection, make sure that the machine is connected to the computer with a USB cable securely.Connecting the Machine to the Computer Using a USB CableCheck4 Make sure that the machine setup is completed.If not, perform setup according to the instructions on our website.Check5 When using IJ Network Tool, click Update to search for the machine again.Canon IJ Network Tool ScreenCheck6 Make sure that the network settings in the machine are identical with those ofthe access point.Refer to the instruction manual provided with the access point or contact its manufacturer to check the accesspoint settings, and then modify the machine settings.How to Set an Encryption KeyCheck7 Make sure that there is no obstruction.Wireless communication between different rooms or floors is generally poor. Adjust the location of the devices.Check8 Make sure that the machine is not placed far away from the access point.The access point is located indoors within the effective range for wireless communication. Locate the machinewithin 164 ft. / 50 m from the access point.Check9 Make sure that there is no source of radio wave interference in your vicinity.If a device (e.g. microwave oven) using the same frequency bandwidth as the wireless station is placed nearby,the device may cause interference. Place the wireless station as far away from the interference source aspossible.Check10 Make sure that the network settings of the computer are correct.Make sure that the computer can communicate with the access point over the wireless LAN.Check11 Make sure that the firewall of the security software is disabled.If the firewall function of your security software is turned on, a message may appear warning that Canonsoftware is attempting to access the network. If the warning message appears, set the security software toalways allow access.If using any programs that switch the network environment, check their settings. Some programs will enable afirewall by default.580
