Using Caller ID Service to Reject CallsIf you subscribe to the Caller ID service, the printer detects the sender's Caller ID. If the sender's ID matchesthe condition specified in this setting, the printer rejects the phone call or fax reception from the sender.Note• This setting may not be supported depending on the country or region of purchase.Contact your telephone company to confirm whether it provides this service.Specify the setting following the procedure below.1. Make sure that printer is turned on.2. Select Setup on HOME screen.Using the Operation Panel3. Select Device settings, and then press OK button.4. Select FAX settings, and then press OK button.5. Select Security control, and then press OK button.6. Select Caller rejection, and then press OK button.7. Select Yes, and then press OK button.The Caller rejection conditions screen is displayed.8. Specify rejection conditions.Use the button to select a setting item and use the button to select Accept or Reject.Anonymous no.Selects whether to reject a phone call or fax reception from an anonymous number.Out of area no.Selects whether to reject a phone call or fax reception out of the subscribed service area.Rejected numbersSelects whether to reject a phone call or fax reception from the specified numbers.9. Press OK button to finish specifying rejection conditions.If you select Reject for Rejected numbers, Register rejected numbers? is displayed on the LCD.Select Yes, and then register the rejected number.For details on how to register the rejected number, see Registering Rejected Number.978
