Displaying Preview ScreenPressing the center Function button allows you to preview an image of the printout on the preview screen.Important• The preview screen is not available when you load the original in the ADF.• In the following conditions, you cannot use the center Function button when the Copy standby screenis displayed.• 2-sided is selected for 2-sidedPrintSetting.• 2-on-1 copy or 4-on-1 copy is selected for Layout.• ON is selected for Collate.When 2-sided, 2-on-1 copy, or 4-on-1 copy is selected and the original is loaded on the platen glass,you can set to display the preview screen after scanning the original is finished.Two-Sided CopyingCopying Two Pages onto Single PageCopying Four Pages onto Single Page• The original will be scanned to display the preview image. Therefore, do not open the document coveruntil the preview screen is displayed.• Originals are rescanned after displaying the preview screen and before copying starts. Therefore, donot open the document cover or remove the original from the platen glass while Scanning document...is displayed.1. Preview of the originalThe original that is set on the platen glass is displayed. If the displayed image is skewed, refer toLoading Originals, reset the original properly, and then display the preview screen again and previewthe original.2. Page sizeA frame showing the selected page size appears over the image. The inside of the frame will be printed.3. MagnificationThe magnification setting, which was set when the preview screen was displayed, is displayed. If thesetting other than Fit to page is selected, you can change the magnification setting using thebutton.629
