Configuring Settings for Device Management Software0U6X-084You can facilitate the collection and management of various information about networked devices by implementingdevice management software, such as imageWARE Enterprise Management Console*, into the network. Informationsuch as device settings and error logs is retrieved and distributed via the server computer. If the machine is connectedto such a network, imageWARE Enterprise Management Console searches the network for the machine by usingprotocols such as Service Location Protocol (SLP) to gather information from the machine, including the power status.SLP settings can be specified via the Remote UI.This section also describes how to configure communication settingsfor the imageWARE Enterprise Management Console plug-ins.* For more information about imageWARE Enterprise Management Console, contact your local authorized Canon dealer.Configuring SLP Communication with Device Management Software(P. 215)Configuring Settings for Device Settings Management(P. 218)To use imageWARE Enterprise Management Console plug-ins● You need to enable dedicated port settings and SNMP settings. For SNMP settings, set [MIB AccessPermission] to [Read/Write] for both SNMPv3 and SNMPv1. plug-in. Dedicated Port Settings (P. 317)Monitoring and Controlling the Machine with SNMP(P. 210)Configuring SLP Communication with Device Management Software1 Start the Remote UI and log on in System Manager Mode. Starting RemoteUI(P. 290)2 Click [Settings/Registration].3 Click [Network Settings] [TCP/IP Settings].Network215
