Chapter 1: Configuration Configuring quality of servicePage 1-260Prioritize TCP ACK To reduce the likelihood of TCP acknowledgement packets being dropped,set this parameter to Enabled. This can improve throughput that the enduser perceives during transient periods of congestion on the link that iscarrying acknowledgements. This parameter, when enabled, can beparticularly useful when running bi-direction FTP sessions over the link. If alink is primarily used for video surveillance, it is recommended to configurethis parameter to Disabled.Quality of Service (QoS) page of BHSThe QoS page of BHS is explained in Table 87.Table 87 QoS page attributes - BHSAttribute MeaningPPPoE ControlMessage PriorityOperators may configure the BHS to utilize the high priority channel forPPPoE control messages. Configuring the BHS in this fashion can benefit thecontinuity of PPPoE connections when there are issues with PPPoE sessionsbeing dropped in the network. This prioritization may be configured in theDiffServ tab in the Configuration menu of the BHS.Prioritize TCP ACK To reduce the likelihood of TCP acknowledgement packets being dropped,set this parameter to Enabled. This can improve throughput that the enduser perceives during transient periods of congestion on the link that iscarrying acknowledgements. This parameter, when enabled, can beparticularly useful when running bi-direction FTP sessions over the link. If alink is primarily used for video surveillance, it is recommended to configurethis parameter to Disabled.
