Chapter 1: Configuration Setting up SNMP agentPage 1-219Configuring SM/BHS’s IP over-the-air accessTo access the SM/BHS management interface from a device situated above the AP, the SM/BHS’sNetwork Accessibility parameter (under the web GUI at Configuration > IP) may be set to Public.Table 74 LAN1 Network Interface Configuration tab of IP page attributesAttribute MeaningIP Address Internet Protocol (IP) address. This address is used by family of Internetprotocols to uniquely identify this unit on a network.Network AccessibilitySpecify whether the IP address of the SM/BHS must be visible to only adevice connected to the SM/BHS by Ethernet (Local) or be visible to theAP/BHM as well (Public).Subnet MaskIf Static IP is set as the Connection Type of the WAN interface, then thisparameter configures the subnet mask of the SM/BHS for RF managementtraffic.Gateway IP AddressIf Static IP is set as the Connection Type of the WAN interface, then thisparameter configures the gateway IP address for the SM/BHS for RFmanagement traffic.DHCP stateIf Enabled is selected, the DHCP server automatically assigns the IPconfiguration (IP address, subnet mask, and gateway IP address) and thevalues of those individual parameters (above) are not used. The setting ofthis DHCP state parameter is also viewable (read only), in the NetworkInterface tab of the Home page.DNS IP AddressCanopy devices allow for configuration of a preferred and alternate DNSserver IP address either automatically or manually. Devices must set DNSserver IP address manually when DHCP is disabled for the managementinterface of the device. The default DNS IP addresses are 0.0.0.0 whenconfigured manually.Preferred DNS Server The first address used for DNS resolution.Alternate DNS Server If the Preferred DNS server cannot be reached, the Alternate DNS Server isused.
