Editing LabelsTo edit a user label:1. Select one or more faders and tap USER LABEL . The footer changes to display a text entry field and fourbuttons, PREVIOUS, NEXT , DONE, CANCEL .2. Enter fader labels using either the software keyboard or an external keyboard connected via one of the threesurface USB ports.3. Scroll through the fader label fields by tapping them, or by tapping PREVIOUS and NEXT .4. Once you are happy with your changes, tap DONE .Port LabelsUser Label:A label given to a port/path/bus from the Summa interface. This is only viewable on the console that it was made on.Port User Label:A label given to a port by the network administrator via H2O. This label is viewable across the Hydra2 network.System Label:A port label generated within an I/O box and viewable across the Hydra2 network.Cloning PathsTo clone a path:1. Select one or more faders, at least one of which must have a path attached.2. Tap CLONE in the control window footer.3. Tap the fader(s) to which you wish to clone the selected path(s).4. Tap CLONE again to confirm your choice.As you tap possible destinations, previews of the potential placements appear to help with your decision. A colourindication system is used to indicate the possible outcome of your choice: green when the destination is empty, orangewhen a path other than a channel is assigned to the fader, and red when a channel path is assigned to the fader.Red is used to indicate channel paths because if a channel is removed from a fader it no longer exists.Once you have selected your destination you are presented with two options, CANCEL or CLONE & OVERWRITEwhich replaces the destination path with a clone of your original selection and removes the original path(s) from thesurface. As channels don’t exist once they are removed from faders, a pop-up appears if you attempt to overwrite achannel, requiring you to confirm your choice.Moving Paths to Different Faders1. Select one or more faders, at least one of which must contain a path.2. Tap MOVE in the control window footer and tap the fader that you wish to move the selected paths to.3. Tap MOVE again to confirm your choice.CALREC Putting Sound in the Picture 79
