THE MONITORING POP-UPThe monitor pop-up allows you to quickly select a monitor source as well as providing detailed controls for theselected output. It is accessed by tapping any of the monitor source select buttons from the Monitor bar.The first two tabs in the monitor pop-up are used for selecting a monitor source. If you have accessed the monitorpop-up for the console monitors, tap any path selector to see the console monitor source select button change to displaythe correct source label and colour, indicating that the selected source is now feeding the console monitors.Favourite Monitor SourcesThree ‘favourites’ boxes are provided towards the bottom left of the monitor pop-up. Any monitor source can be placedinto a favourites box making it more readily available during operation—drag and drop your three most commonly usedmonitor sources into these favourite boxes to speed up monitor source switching.Monitoring External InputsThe external inputs tab allows you to select any external input as a monitor source.Settings• Listen Modes: Allow you to monitor the source at either its current path width (full), using the left, right and centrespeakers (3 stereo), in stereo or mono.• Insert: Switch the monitor insert on and off.• Misc Functions: Various functions ranging from leg routing options, LFE on/off, phantom centre (meaning to route theC monitor feed to both left and right speakers) and polarity invert right (which allows you to monitor the stereo contentof your monitor source by cancelling out the mono content).• APFL Settings: Gives control over where the PFL bus is routed along with an ‘APFL clear’ button to clear all• AFL/PFL/Output Listen routing across the surface.• Solo Legs: Each leg of the monitor source has its own solo checkbox, checking any of these disables all other legs,so each can be auditioned individually.The controls along the bottom of the pop-up are visible whichever tab is selected:• Favourites: Allows you to make up to three monitor sources available for quick selection at any time.Simply drag and drop sources from the first two monitor pop-up tabs.• Console LS Controls: Control the level of the console monitors and cut or dim the feed.• Dim Adjust: Set how much the monitor level will be reduced when DIM is selected.• AFL Trim: Adjust the level of the AFL feed between -10dB and +10dB.• PFL Level: Sets the level of the dedicated PFL output.The settings tab contains settings for the currently accessed monitor feed. The individual controls are explained inmore detail in the following pages.CALREC Putting Sound in the Picture 109
