CalAmp Viper 100 User Manual

Contents

CalAmp Viper 100 User Manual Manual pdf 96 page image

#9 Viper_SC_Manual_001-5008-000_Rev12e.docx | Page 894.8.2 STATUSFigure 69 – Network Management  Status4.8.3 MAINTENANCEThe Network Maintenance page allows the user to make changes to a single Viper device or to the entire Viper network.This allows the user to make changes to the remote units' neighbor tables.Figure 70 – Network Management  Maintenance― Delete Station. User entered RF MAC Address of the station to be deleted from the Neighbor Table of all Viper SCs inthe network.― Replace Station. User entered RF MAC Address of the Viper to be replaced and the new RF MAC Address (that willreplace the old Viper SC). This will update the Neighbor Table of all Viper in the network.― Change ND mode. Select to change the Neighbor Discovery mode of all Viper in the network to Manual-Scan, Auto-Scan, or Disable. Refer to Section 4.8.1 for a description of Neighbor Discovery modes.― Save Configuration. Click to send a save configuration command to all Viper in the network.― Get Status. Click to send a command to all Vipers in the network. Command results are displayed on the NetworkManagement  Status page.― Single Station. Check to enter the single RF MAC Address of the Viper SC module commands will be sent to. If thisoption is selected, the command will be sent to an individual Viper SC instead of being sent to all Viper SCs in theNetwork.