CalAmp Viper 100 User Manual

Contents

CalAmp Viper 100 User Manual Manual pdf 79 page image

#9 Viper_SC_Manual_001-5008-000_Rev12e.docx | Page 72Example 2In this example the source netmask is 255.255.255.0, so messages originating from source IP addresses: 172.30.51.1-172.30.51.254 and from ports: 5555-6000 will be passed through the VPN tunnel. All other messages will be blocked(assuming that “Block non-VPN Traffic” is enabled).The destination IP address is 0.0.0.0 and the destination port range is 0 to 0. So messages destined to any IP address andany destination port will be passed through the VPN tunnel.4.6 STATISTICSFrom the navigation frame select Statistics to view statistics reporting the amount of traffic sent and received by each ofthe three interfaces. This page also reports statistics gathered from the Airlink that can indicate the quality of the RF links.All definitions given below use the following convention: RX (or Input) = data received from a lower network layer TX (or Output) = data transmitted to a lower network layer.Figure 57 – Statistics