CalAmp Viper 100 User Manual

Contents

CalAmp Viper 100 User Manual Manual pdf 101 page image

#9 Viper_SC_Manual_001-5008-000_Rev12e.docx | Page 94200-Firmware Version: . FIRM-03_10-R200-ASD Data Map: . . . 2.0200-Radio Circuit Board: 0.10200-Radio Serial Number: 405163200 Radio Model Number: 823-5028-452Check that the “Firmware Version:” shows the latest firmware revision.Figure 72 – Using Windows Command Prompt to upgrade Radio Firmware5. Restart the Viper SC. You can restart the Viper SC by typing “stationreset” in the CLI then pressing enter.6.3 VERIFY FILE INTEGRITY1. Using your browser, connect to the unit’s IP address.2. Enter the user name and password. Allow the Welcome page to load.3. In the left pane, select UNIT STATUS. The Unit Identification and Status pane should display the newly upgradedfirmware in its Banner and the H/W Status should also show Ok.4.If the message in the result screen points out that file(s) failed the integrity check, retry the FTP transfer for the failedfiles(s) again. If the problem persists, please HAVE THE PACKAGE CONTROL RESULTS READY AND CONTACT CALAMPTECHNICAL SERVICES.