CalAmp Viper 100 User Manual

Contents

CalAmp Viper 100 User Manual Manual pdf 33 page image

#9 Viper_SC_Manual_001-5008-000_Rev12e.docx | Page 264 WEB INTERFACEViper is designed for easy installation and configuration. All operating parameters are set using a web browser. A built-inweb server makes configuration and status monitoring possible from any browser-equipped computer, either locally orremotely. The Interface is divided into two frames. On the left, the navigation frame allows the user to navigate the mainmenu. Unit Status (see Section 4.1) Setup Wizard (see Section 4.2) Basic Setup (see Section 4.3) Advanced Setup (Section 4.4) Security (see Section 4.5) Statistics (see Section 4.6) Maintenance see (Section 4.7) Network Management (see Section 0)The navigation frame also contains the Save Config and Reset Unit command buttons.― Save Config. This command saves the Viper SC parameters into flash memory. Failure to use this command will resultin the loss of temporarily entered parameters when the unit is reset.― Reset Unit. Once satisfied all parameters have been applied and saved, use this command to make flash changespermanent. When a unit is reset, a 20-second station reset timer counts down. Status reports Ready when reset iscomplete.Figure 17 – Web Management Welcome ScreenThe frame on the right displays the selected web page and any system commands applicable to the current page.