CalAmp Viper 100 User Manual

Contents

CalAmp Viper 100 User Manual Manual pdf 35 page image

#9 Viper_SC_Manual_001-5008-000_Rev12e.docx | Page 28― IP Forwarding Mode. Display Bridge/Router. Default = Bridge. IP forwarding mode is configured in Section 4.3.1.― Station Relay Point. Display Yes/No. Default = No. The Station Relay Point is configured in Section 4.3.1.― Multi-Speed Mode. Display Enabled/Disabled. Default = Disabled. Refer to Section 4.3.1 for multispeed configuration.― Mode. Indicate the mode of operation (ANSI, ANSI 900, ETSI)― On-line diagnostics Interval. Displays the time interval (in seconds) when the On-line Diagnostics string will betransmitted. This interval is configured in Section 4.3.1.2.― VPN Status. Displays the status of the VPN (virtual private network). OK/Ready when operational. If device is notoperational display will read Not Ready and a reason will be shown (Ex. VPN service disabled).― Unit Status. Displays the status of the Viper SC and reports any errors. If you do not receive the OK indicator (EX. Error:Power On Self Test FAILURE, Warning: Radio TX Synthesizer lock failure N/A), use the ACKNOWLEGDE UNIT STATUS andREFRESH buttons to reset the modem. If the problem persists, contact CalAmp Technical Services for additionalinformation.― Refresh. Click to Refresh the parameters on the current page.― Acknowledge Unit Status. Allows the user to acknowledge and clear errors. Errors remain stored, even after cyclingpower, to aid in troubleshooting intermittent faults. Click to return web page displays and Status LED function tonormal operation.4.1.2 DIAGNOSTICSFrom the navigation frame, select Unit Status  Diagnostics to view diagnostic data for the local device. Each Viper can beconfigured to continually monitor and report its operating conditions and local environment.Figure 19 – Diagnostics Info― Date and time. Displays the time and date. To configure date and time using an SNTP server, refer to Section 4.4.6 –Advanced Setup  Time Source. The SNTP server must also be accessible via the user’s LAN or Internet connection.― Time Since Reset. Displays the amount of time since the unit was last reset. Formatted as Days: Hours: Minutes:Seconds.