Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C | Page 61Global SettingsNote: All selections in this tab apply to all Vipers in the network unless you check the Single Station check box near thebottom of the tab and enter the RF MAC Address of the Viper to which the change will be applied.Delete StationEnter the RF MAC Address of the station to be deleted from the Neighbor Table of all Vipers on the network. Tosave this change to the configuration after remote operation, place a check in the check box at the right.Replace StationEnter the RF MAC Address of the unit that will be removed and the RF MAC Address of the Viper that will replaceit. To save this change to the configuration after remote operation, place a check in the check box at the right.Change ND modeThis setting allows you to change the Neighbor Discovery (ND) mode for all Vipers in the network. When thisoption is set, you can select Manual Scan, Auto-Scan, or Disabled for all Vipers. To save this change to theconfiguration after remote operation, place a check in the check box at the right.Change TCP Proxy ModeYou can change the TCP Proxy mode for all Vipers in the network to enabled or disabled. To save this change to theconfiguration after remote operation, place a check in the check box at the right.Clear Neighbor TableTo clear the Neighbor Tables for all Vipers in the network, select this setting. To save this change to theconfiguration after remote operation, place a check in the check box at the right.Save ConfigurationThis will send a Save Configuration command to all Vipers in the network.Get StatusThis will send a Get Status command to all Vipers in the network. The status will be displayed in the Neighbor Tabletab of the RF Network Settings page.Single StationIf this check box is checked and the RF MAC Address of a Viper on the network is entered into the field below, anyother selection made in this tab will apply to the Viper whose RF MAC Address is entered. When the box is notchecked, any setting made in this tab will apply to all Vipers on the network.Apply — Click Apply to apply any changes you have made to Global Settings.Cancel — Click Cancel to cancel any changes you may have made to any settings in this tab.4.3.5. VLANVLAN (Virtual Local Area Network) is the fifth (from left) tab of the RF Network Settings page. To navigate to this tab,select RF Network Settings from the main menu and click VLAN. This tab allows you to make VLAN Configurationsettings for the RF Network.VLAN is available in both Bridge and Router mode. In Bridge mode, the user can specify either tagged or untaggedoperation for the RF interface when VLAN is enabled. In Router mode, the RF interface can only be tagged when VLANis enabled.
