Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C | Page 333.7.2. SETUP WIZARD STEP 2: NETWORK IP SETTINGSThe page for Step 2 of the Viper Setup Wizard allows you to set the IP address, Network Mask, and Default Gateway forthe Viper.Figure 21 – Viper Setup Wizard Step 2Enter an IP Address, Network Mask, and Default Gate way for the Viper if applicable.- The default IP Address is 192.168.205.1.- The default Network Mask is 255.255.255.0.- The Default Gateway is 0.0.0.0There are several important considerations to be aware of for these settings in addition to the explanation on the page.Each Viper should be configured with a unique IP address. (If you are in the habit of taking the default settings on eachpage, they will all have the same address of 192.168.205.1.) The Network Mask determines whether units areconfigured to be on the same subnet. If the subnet has a Default Gateway, its IP address should be entered in the fieldprovided. Note: Once you have changed the IP Address and applied the setting, and after you have reset the Viper tomake it take effect, you will need to enter this new IP address in your browser Address Bar to access the web interfaceof the Viper.When finished, click Apply to save any settings you have made in this page and then click Next to proceed to Step 3 onthe following page.Note: If you change the IP Address and the Viper is reset, you will need to change the IP Address in your browser’sAddress bar to this address (and enter your user name and password) to access this Viper.
