Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C | Page 41Power ManagementWhen enabled, power management will allow the unit to go into a low-power mode when the ignition-sense is off(when the white wire is disconnected from the red wire or B+ supply). The default setting is disabled.Auto ResetAuto Reset allows you to set a time duration, after which the unit will automatically reset itself. This is disabled bydefault.Unit Reset IntervalIf Auto Reset is Enabled, enter the number of minutes (after each power up —ten minutes minimum) the unitshould be up between resets. The default setting is disabled.Temperature SettingSelect whether temperature will be reported in degrees Celsius or degrees Fahrenheit on the Unit Status tab of theHome page and in Online Diagnostics messages. The default setting is Celsius.VLAN ModeWhen the VLAN mode is enabled, the Ethernet interface can be configured to operate in “tagged” or “untagged”mode, the RF interface operates in “tagged” mode and the Serial ports operate in “untagged” mode.Untagged: Devices on this interface are not using VLAN tags. Incoming (ingress) packets are tagged with the portVLAN ID (PVID). VLAN tags are removed on outgoing (egress) packets.Tagged: Devices on this interface are using VLAN tags. Incoming (ingress) packets are forwarded with their VLANID. Outgoing (egress) packets keep their VLAN tags.See configuration tabs for each interface for more specific VLAN configuration options.Management VLANWhen Management VLAN is enabled, access to the unit will be allowed only through the Management VLAN ID.Management VLAN IDThe ID is a value from 1 to 4094, inclusive.Save — Click Save to save any changes you have made in this tab. See Note below.Cancel — Click Cancel to cancel any changes you may have made to any of the settings in this tab.Note: If you change the VLAN Mode, Management VLAN, or Management VLAN ID setting in this tab, as indicated bythe yellow alert symbol ( ), a reset of the Viper is required before the setting will take effect.4.2. RADIO SETTINGSThe Radio Settings page contains three tabs: RF Settings, CWID, and RF Tests.4.2.1. RF SETTINGSRF Settings is the first (left-most) tab of the Radio Settings page. To navigate to this tab, select Radio Settings from themain menu. In this tab, you can view the Radio Capabilities and configure the channel number, frequency range fortransmit and receive, bandwidth, transmit power, and other settings that determine how the radio will communicate.
