Bosch Access Easy Controller Hardware Manual

Also see for Access Easy Controller: Quick installation

Access Easy Controller How to Install Reader and Field Devices | en 45Bosch Security Systems Hardware Manual Ver 2.0.0 | 2006.076.6 S-Series Fingerprint Card Reader1. Configure the reader for card, PIN operation and fingerprint enrolment, please refer tothe Access Easy Controller Software User Manual for detail in enabling the card and PINoperation and fingerprint enrolment manual for detail in indexing the fingerprint.2. Present a card to the reader.3. The fingerprint reader should then begin a fast flickering of red indicating that fingerprintshould be scanned.4. Once fingerprint is verified, the reader should then begin a slow flush of the green indi-cating that the PIN code should be entered.Enter the card's PIN code by slowly pressing the numeric keys on the reader's keypad.After entering the last digit, press the Enter key to complete PIN entry.Result: An audible beep will be heard after each key is pressed.5. Depending on the setup of the controller database for the card used in the previous step,one of two events will occur within a second after pressing the Enter key in the previousstep. Note that either response indicates that the reader and keypad are working.– If the card is configured to allow access through the reader and the correct PIN codewas entered, then the green LED will turns off for a few seconds indicating thataccess has been granted.– Or, if the database has not yet been fully configured, then the green LED will flashrapidly for two of three seconds indicating that access has been denied