Access Easy Controller Table of Contents | en 3Bosch Security Systems Hardware Manual Ver 2.0.0 | 2006.07Table of Contents1 Before You Begin 72 Overview of Access Easy Controller™ 82.1 Basic Access Easy Controller Configuration 93 System Layout 113.1 Single controller System 123.2 Two Controller Systems 133.3 Three Controller Systems 143.4 Controller Specifications 154 Is Access Easy Controller the Correct Choice for Your Client? 174.1 Checklist for Evaluating a Potential Access Easy Controller Application 174.2 When the network does not meet the requirements of Access Easy Controller 195 How to Install the Access Easy Controller 235.1 Preliminary 235.2 Controller Installation 246 How to Install Reader and Field Devices 316.1 HID MiniProx Reader 356.2 HID ProxPoint Reader 376.3 HID ProxPro Reader 396.4 HID ProxPro Reader with Keypad 416.5 S-Series Card Reader 436.6 S-Series Fingerprint Card Reader 456.7 Field devices using I/O board 466.7.1 Wiring Diagram for 2 State Supervised Input points 466.7.2 Wiring Diagram for 2 State Non-Supervised Input points 476.7.3 Wiring Diagram for 4 State Supervised Input points 486.8 Entry and Arm/Disarm Reader 496.8.1 Wiring diagram of a HID Compliant Entry and Arm/Disarm Reader 506.8.2 Wiring Diagram of a S-Series Entry and Arm/Disarm Reader 517 Common Alarm Output 527.1 Overview 527.2 Alarm (All Input Points) 527.3 Door Forced Opened and Door Held Opened 527.4 Panel AC Failure 537.5 Controller Tamper 537.6 Duress 538 How to Set Up the Access Easy Controller and the Computer 558.1 Overview 55