Bosch Access Easy Controller Hardware Manual

Also see for Access Easy Controller: Quick installation

Access Easy Controller Is Access Easy Controller the Correct Choice for YourClient? | en 19Bosch Security Systems Hardware Manual Ver 2.0.0 | 2006.07X An IP address for the controller.X The subnet mask that is used on the network (or sub-network) to which the Access EasyController will be connected.X If the controller will need to go through a gateway to communicate over the network,then the IP address of the gateway will be needed.X Also, if the e-mail feature is to be used, then IP Address of the SMTP mail server will berequired.Request this information from the customer and record it below.Controller IP address:_ _ _ _. _ _ _ _. _ _ _ _. _ _ _ _Subnet mask:_ _ _ _. _ _ _ _. _ _ _ _. _ _ _ _Gateway address:_ _ _ _. _ _ _ _. _ _ _ _. _ _ _ _Outgoing SMTP mail server:_ _ _ _. _ _ _ _. _ _ _ _. _ _ _ _Outgoing mail server port:_ _ _ _Controller's E-mail account name and domain:_ _ _ _. _ _ _ _. _ _ _ _Finally, note the following information that will be needed by the installer.X Location where the Access Easy Controller is to be installed:X Location of the wall jack or hub to be used by the controller to connect to the customer'snetwork:4.2 When the network does not meet the requirements of AccessEasy ControllerThe following paragraphs provide expanded discussion of network items that were identifiedas not compatible with Access Easy Controller during completion of the network survey.For each item, at least one solution will require hardware or software changes within the cus-tomer's computer. These modifications should always be done by customer, their IT depart-ment, or their supplier of IT hardware and systems. Bosch Security systems personnel shouldnot modify the hardware and/or software configuration of customer's computer.