Bosch AUTODOME IP starlight 5000i IR User Manual

Also see for AUTODOME IP starlight 5000i IR: User manual User manual Instruction manual

12 en | General AUTODOME IP starlight 5000i IR2023-01 | 1.3 | User Manual Bosch Security Systems3 General3.1 IdentificationDevice nameEnter a unique, unambiguous name for the device (for example, the installation location of thedevice). This name should be easy to identify in a list of devices in your system. The devicename is used for the remote identification of a unit, such as in the event of an alarm.Do not use any special characters, for example &, in the name. Special characters are notsupported by the system's internal management.Device IDEnter a unique identifier for the device. This ID is additional identification for the device.Video nameEnter a name for the video (for example, HDR ON).Host nameEnter a host name.Initiator extensionAdd text to an initiator name to make identification easier in large iSCSI systems. This text isadded to the initiator name, separated from it by a full stop. (You can see the initiator name inthe System Overview page.)3.2 User ManagementThe section Authentication modes provides information about the authentication modes setin the camera. A checkmark appears in the checkbox to the left of the mode if the mode is set.If the mode is not set, the phrase, “No certificate installed” appears to the right of the modename.PasswordThis field indicates if a password is set for the camera.CertificateA check mark in this check box indicates that at least one certificate is loaded onto thecamera. If no certificates are loaded, then “No certificate installed” appears to the right of thetext.The Escrypt certificate is a root certificate for Bosch Security Systems that proves that thedevice meets the following criteria:– It originates from a Bosch factory that is a secure environment.– It has not been tampered with.Escrypt is a Bosch company and Certificate Authority (CA).Active directory server (ADFS)A check mark in this check box indicates that the camera uses an active directory server. If thecamera does not use ADFS, then “No certificate installed” appears to the right of the text.Password managementA password prevents unauthorized access to the device. You can use different authorizationlevels to limit access.Proper password protection is only guaranteed when all higher authorization levels are alsoprotected with a password. Therefore, you must always start from the highest authorizationlevel when assigning passwords.You can define and change a password for each authorization level if you are logged into the“service” user account.