Bosch AUTODOME 7100i User Manual

Also see for AUTODOME 7100i: Installation manual Installation manual

AUTODOME 7100i Configuration | en 23Bosch Security Systems B.V. User Manual 2022-12 | V01 | DOCRestore settingsClick Defaults to restore the factory defaults for the camera. A confirmation screen appears.Allow several seconds for the camera to optimize the picture after a reset.Click Confirm in each dialog box that opens to complete a factory reset of the device.This action deletes all third-party apps and resets all settings to defaults (including networksettings).!Caution!Do not remove power to the unit during a factory default or a firmware update. Wait at leasttwo minutes for the default process to complete. If the unit appears to be "frozen" after twominutes, then reboot the unit. Refer to Troubleshooting for more details.4.4.1.1 Display StampingVarious overlays or “stamps” in the video image provide important supplementary information.These overlays can be enabled individually and are arranged on the image in a clear manner.The drop-down menus below allow the configuration of the individual stamping options. Therespective sample windows show a preview of the configured text and background styles.Click Set to apply the changes.Global configurationiNotice!These options can also be configured individually for all stamping settings.Any changes to the global configuration settings will be applied to all stamping settings!Stamping sizeSelect the desired font size of the overlays on the OSD: Normal or Large.Select Custom to enable the Font size (‰) field.Font sizeEnter a number for a custom size (percentage) of the font, from 1 to 1000.Text colorSelect the color for the stamps to be displayed in.Background colorSelect the background color for the stamps to be displayed in.If you have enabled the Transparent background option, the background color is notdisplayed in the OSD.Transparent backgroundCheck this box to make transparent the stamp background on the image.Camera name stampingThis field sets the position of the camera name overlay. It can be displayed at the Top, at theBottom or at a position of your choice that you can then specify using the Custom option. Orit can be set to Off for no overlay information.1. Select the desired option from the list.2. If you select the Custom option, additional fields are displayed where you can specify theexact position (Position (XY)).3. In the Position (XY) fields, enter the values for the desired position.Select the position of the camera name overlay in the drop-down box. It can be displayed atthe Top, at the Bottom, or at a position of choice using the Custom option, or it can be set toOff for no overlay information.