Bosch AUTODOME 7100i User Manual

Also see for AUTODOME 7100i: Installation manual Installation manual

AUTODOME 7100i Configuration | en 17Bosch Security Systems B.V. User Manual 2022-12 | V01 | DOCIf you decide to create alternative daylight saving time dates by editing the table, note thatvalues occur in linked pairs (DST start and end dates).First, check the time zone setting. If it is not correct, select the appropriate time zone andclick Set.1. Click Details to edit the DST table.2. Click Generate to fill the table with the preset values from the unit.3. Click one of the entries in the table to make changes. The entry is highlighted.4. Click Delete to remove the entry from the table.5. Choose other values from the list boxes under the table, to change the selected entry.Changes are immediate.6. If there are empty lines at the bottom of the table, for example after deletions, add newdata by marking the row and selecting values from the list boxes.7. When finished, click OK to save and activate the table.Time server addressThe camera can receive the time signal from time server using various time server protocols,and then use it to set the internal clock. The unit polls the time signal automatically once everyminute.Enter the IP address of a time server here.You can choose to have the DHCP server provide the IP address of the time server, byselecting the Overwrite by DHCP option.Time server typeSelect the protocol that is supported by the selected time server.– Select Time protocol if the server uses the protocol RFC 868.– The SNTP protocol supports a high level of accuracy and is required for specialapplications and subsequent function extensions.– Select TLS protocol if the server uses the RFC 5246 protocol.– Select Off to disable the time server.Click Set to apply the changes.4.2 Web Interface4.2.1 AppearanceYou can adapt the appearance of the web interface and change the website language to meetyour requirements.You can use GIF or JPEG images to replace the device logos. The image can be stored on aweb server.Make sure that a connection to the web server is always available to display the image. Theimage files are not stored on the device.To use the original graphics, delete the entries in the Device logo field.Website languageSelect the language for the user interface.The default language is English. After selecting a different language, click the Set button. Thepage refreshes automatically. The GUI now displays field names and options as well as OSDmessages in the selected language.Show VCA metadataWhen video content analysis (VCA) is activated, additional information is displayed in the livevideo stream. With the MOTION+ analysis type, for example, the sensor fields in which motionis recorded are marked with yellow rectangles.