ADEMCO Vista-10SEa User Manual

Also see for Vista-10SEa: Installation and setup guide User guide

ADEMCO Vista-10SEa User Manual Manual pdf 12 page image

– 12 –SECURITY CODES (cont)Duress CodeThis feature is intended for use when you are forced to disarm or arm thesystem under threat. When used, the system will act normally, but cansilently notify the central station of your situation, if that service has beenprovided.The Duress code is entered in the same manner as other codes, and is definedas User No. 8.IMPORTANT: This code is useful only when connected to a centralstation.To Change Your Master CodeEnter the original Master code + [8] + [2] + new Master code + new Mastercode again.The keypad will beep 3 times, indicating acceptance of the new Master code.Quick ArmingAsk your installer if "Quick Arming" is active for your system; if so, checkhere:If your system supports Quick Arming, the [#] key can be pressed in place ofthe security code when arming the system. The security code is alwaysrequired, however, when disarming the system.Phone (Voice) ModuleAsk your installer if your system includes a phone module; if so, check here:If your system includes a phone module, your installer will have programmeda 2-digit phone access code for your system. Be sure to obtain this phone codefrom your installer.Complete information regarding the use of this phone access feature isprovided in a separate manual entitled PHONE ACCESS USER'S GUIDE,which accompanies the phone module.www.PDF-Zoo.com