Installation ManualH3C S7500 Series Ethernet Switches Chapter 5 System Commissioning5-7BOOT_FLASH type : M29W040BFlash Size : 32MBMemory Size : 256MBS7506 main board self testing................................SDRAM Data lines Selftest.................................OK!SDRAM Address lines Selftest..............................OK!SDRAM fast selftest.......................................OK!Please check LEDs.....................LEDs selftest finished!CPLD selftest.............................................OK!FPGA selftest.............................................OK!The switch Mac address is .....................0000.0309.0004Press Ctrl+B to enter Boot Menu... 5Auto-booting...Auto booting file is srpuprj.appDecompress Image..........................................................................................................OK!Starting at 0x60000.....................................................................................................................................................................................................................................................User interface Aux0/0 is availablePress ENTER to get started.The display of the above information indicates the completion of the switchauto-startup.Press Enter. The following prompt appears on the configuration terminal, whichindicates that you can start configuring the switch.Note:H3C S7500 series switches provide a variety of command views. For the specificdescriptions on the configuration commands and command line interfaces, refer toH3C S7500 Series Ethernet Switches Operation Manual and H3C S7500 SeriesEthernet Switches Command Manual.
