1-24Configuring VLAN MappingRefer to section VLAN Mapping for information about VLAN mapping.Configuration prerequisitesz The ACL rules used for traffic classification have been defined. Refer to the ACLmodule of this manual for information about defining ACL rules.z The ports on which the configuration is to be performed have been determined.z The VLAN ID to be set for the packets has been determined.Configuration procedureFollow these steps to configure VLAN mapping:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet portviewinterface interface-typeinterface-number —Configure VLANmappingtraffic-remark-vlanid inboundacl-rule remark-vlanremark-vlanidRequiredBy default, VLAN mappingis not configured.Configuring Queue SchedulingRefer to section Queue Scheduling for information about queue scheduling.Configuration prerequisitesThe algorithm for queue scheduling to be used and the related parameters have beendetermined.Configuration procedureFollow these steps to configure queue scheduling in system view:To do… Use the command… RemarksEnter system view system-view —Configure queueschedulingqueue-scheduler { strict-priority |wfq queue0-width queue1-widthqueue2-width queue3-widthqueue4-width queue5-widthqueue6-width queue7-width | wrrqueue0-weight queue1-weightqueue2-weight queue3-weightqueue4-weight queue5-weightqueue6-weight queue7-weight }RequiredBy default, the queuescheduling algorithmadopted on all the ports isWRR. The default weightsof the eight output queuesof a port are 1, 2, 3, 4, 5, 9,13, and 15 (in the orderqueue 0 through queue 7).Follow these steps to configure queue scheduling in Ethernet port view:
