1-22Configuring Line RateRefer to section Line Rate for information about line rate.Configuration prerequisitesz The port on which line rate configuration is to be performed has been determined.z The target rate and the direction of rate limiting (inbound or outbound) have beendetermined.Configuration procedureFollow these steps to configure line rate:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Configure line rateline-rate { inbound |outbound } target-rate[ burst-bucketburst-bucket-size ]RequiredSpecify a committedinformation rate (CIR) for thetarget-rate argument, andspecify a committed bust size(CBS) for theburst-bucket-size argument.By default, line rate isdisabled.Configuration examplez Configure line rate for outbound packets on Ethernet 1/0/1.z The rate limit is 1,024 KbpsConfiguration procedure: system-view[Sysname] interface Ethernet1/0/1[Sysname-Ethernet1/0/1] line-rate outbound 1024Configuring Traffic RedirectingRefer to section Traffic Redirecting for information about traffic redirecting.Configuration prerequisitesz The ACL rules used for traffic classification have been defined. Refer to the ACLmodule of this manual for information about defining ACL rules.z The traffic redirecting destination has been determined.z The ports that need this configuration have been determined.
