3Com 4005 Installation And Maintenance Manual

Also see for 4005: Key Information Guide Datasheet

Contents

3Com 4005 Installation And Maintenance Manual Manual pdf 27 page image

Installing the Cable Management Device 27Installing the CableManagement DeviceAn optional cable management device is included in the Switch 4005 hardwarekit. The Cable Management Device helps to organize module cables from eitherthe top or the bottom of the chassis.You may have other types of cable management devices at your site; if so, followthe manufacturer’s suggested installation procedures.To install the cable management device, follow these steps:1 Read the section titled “Preinstallation Guidelines” in this chapter as well as allsections titled “Safety Information.”2 Place the cable management device flush up against the top or bottom of thechassis as shown in Figure 8.Figure 8 Position of the Cable Management Device3 Using a Phillips screwdriver, secure the cable management device to the rack withtwo screws (and with clip nuts if you are using these).a If you use clip nuts, consider attaching nylon flat washers to the back of thescrews (to protect the face of the cable management device) and place theclips nuts on the rack rail.b Tighten the screws completely.The Switch 4005 accessories package includes fourteen plastic ties that can beused to bundle the interface module cables into logical groups for easiermanagement.CabledevicemanagementFlange