3Com 4005 Installation And Maintenance Manual

Also see for 4005: Key Information Guide Datasheet

Contents

3Com 4005 Installation And Maintenance Manual Manual pdf 26 page image

26 CHAPTER 4: SWITCH 4005 C HASSISTable or ShelfInstallationTo install the chassis on a table or shelf, follow these steps:1 Read the section titled “Preinstallation Guidelines” in this chapter as well as allsections titled “Safety Information”.2 Using two people, lift the chassis onto the table or shelf.3 Remove the four rubber feet from the hardware kit.4 Position the chassis on its side so that you can access the bottom of the chassis.5 Remove the protective covering from the adhesive on the rubber feet, and attachone foot at each corner within the scribed squares. See Figure 7.Figure 7 Attaching Rubber Feet to the Switch 4005 Chassis6 Position the chassis so that it rests upright and level on its rubber feet.7 Ensure that the front, sides, and the rear of the chassis are unobstructed and thatthey are in compliance with ventilation requirements.