1.3 Model Numbers and Nameplate ChecksPlease perform the following tasks after receiving the Z1000 Bypass• Inspect the Z1000 Bypass for damage.If the Z1000 Bypass appears damaged upon receipt, contact the shipper immediately.• Verify receipt of the correct model by checking the information on the nameplate.• If you have received the wrong model or the Z1000 Bypass does not function properly, contact your supplier.If you find any irregularities in the above items, contact the shipping company, the distributor or representative you purchasedthe Z1000 Bypass from or your Yaskawa office immediately. The Z1000 Bypass is thoroughly tested at the factory. Anydamages or shortages evident when the equipment is received must be reported immediately to the commercial carrier thattransported the material. Shipping damage is not covered by the Yaskawa warranty. After unpacking and inspecting for damage,verify that internal wire connections have not come loose during shipment by spot checking wire terminations with ascrewdriver or the appropriate tool. Z1000 Bypass storage must be in a clean and dry location. Maintain the factory packagingand provide covering as needed to protect the Z1000 Bypass from construction site dirt, water, debris and traffic prior to andduring construction.u Drive NameplateFEDCBAA – Software versionB – Serial numberC – Lot numberD – Output specificationsE – Input specificationsF – AC drive modelFigure 1.1 Drive Nameplate Information ExampleCIMR - Z U 2 A 0021 F A ADrive Z1000Series No. EnclosureType DesignRevisionOrderNo. CustomizedSpecificationsA Standard modelNo. RegionCodeU USAIP00/Open-TypeFIP20/NEMAType 1ANo. Voltage ClassNo. EnvironmentalSpecificationA Standard3-phase, 200-240 Vac23-phase, 380-480 Vac4No. Drive ModelAmp Rating1.3 Model Numbers and Nameplate Checks28 YASKAWA ELECTRIC SIEP YAIZ1B 01E YASKAWA AC Drive – Z1000 Bypass Technical Manual
