17Installation InstructionsWiring16. Wire the collector ring based on whether there isa running light or not.• Without Running Light - see Figure 17-1.(a) Refer to the VRI-iS Slip Ring Wiring FieldInstall.(i) Wire the slip ring to the resolver cable(from control panel) and four positionterminal strip.(ii) Wire 50 foot VRI-iS cable to the four po-sition terminal strip.(b) Use wire ties to secure the slip ring wiresand VRI-iS cable to wire tie holders on sen-sor bracket.• With Running Light - see Figure 17-2.(a) Wire the running light to collector ring. Referto the Running Light Field Wiring.(b) Refer to the VRI-iS Slip Ring Wiring FieldInstall.(i) Wire the slip ring to the resolver cable(from control panel) and four positionterminal strip.(ii) Wire 50 foot VRI-iS cable to the four po-sition terminal strip.(c) Use wire ties to secure the slip ring cableand VRI-iS cable to wire tie holders on sen-sor bracket.17. Install the cover on the collector ring.18. If you know the GPS coordinates for the pivotpoint, continue with Use Edit to Setup ControlPanel for GPS Position in the Troubleshoot-ing section on page 74 (ICON5/X) or 76(ICON10/1). If not, continue with TemporarilyInstall GPS Position Tower box on the next page.46254351Figure 17-1 Aeromotive Collector Ring Shown1. Slip Ring Wires2. VRI-iS Cable3. Terminal Strip4. Wire Tie5. Wire Tie Holder6. Sensor Bracket564567312Figure 17-2 Aeromotive Collector Ring Shown1. Running Light Cable2. Slip Ring Wires3. VRI-iS Cable4. Terminal Strip5. Wire Tie6. Wire Tie Holder7. Sensor Bracket
