15Mounting Using the Bracket1. Using appropriate screws or other hardware, secure the bracket.2. Insert the scanner and insert the bracket knobs to lock the scanner inposition.3. Attach the Cigarette Lighter Power Cord to the rear of the scanner andplug the adapter end into a dash mounted 12V DC socket.4. Attach a suitable mounted mobile antenna to the antenna jack on theback of the scanner.Mounting Using the DIN-E SleeveIf you are unsure about how to install your scanner in your vehicle using theoptional DIN-E sleeve, consult your automobile manufacturer, dealer, or aqualified installer. Before installing, confirm that your scanner fits in the desiredmounting area and you have all the necessary materials to complete the task.Your scanner requires a 2 x 7-1/8 x 5-5/16 inch (50 x 180 x 135 mm) mountingarea. Allow an additional 2-3/8 inch (60mm) space behind the unit for connectorsand wires.1. Remove the bracket if it is attached.2. Remove the four Philips screws from four small tabs on the rear of thecase that secure the outer metal case and pull off the case (toward therear) with care.3. Install the DIN sleeve into the opening in your dashboard, lip facing out.4. Push out the top and bottom tabs to hold the sleeve firmly in place.
