Sony ZRD-1 Installation Manual

Also see for ZRCT-100: Operating instructions Operating instructions

6-48 (E) ZRD-1/ZRD-2/ZRCT-100/ZRCT-200System for 3D Dual Input modeIn the case that the DisplayPort connectors are used to input the 3D video, input the L signal (60 Hz) tothe DisplayPort 1 connector, and input the R signal (60 Hz) to the DisplayPort 2 connector.In the case that the DVI connectors (ZRCT-100 only) are used to input the 3D video, input the L signal (60Hz) to the DVI 1 connector, and input the R signal (60 Hz) to the DVI 3 connector.From the display controller, the 3D video signal (120 Hz) in which the L signal and the R signal arearranged alternately is output.From the 3D SYNC OUT connector, the 3D sync signal generated in the display controller is output inaccordance with the picture output’s timing, and then the 3D sync signal controls 3D glasses via an emit-ter.Notice on equipment and connectionThe following emitter and 3D glasses are recommended.. Emitter: AD025-RF-X1. 3D glasses: TDG-BT500AAbout emitterIf you use the emitter except for the recommendation, be sure to use the emitter with a cable length of 3 mor less.About cableFor the 3D SYNC IN connector, connect a cable with length of 3 m or less.DisplayPort 1orDVI 1 ()DisplayPort 2orDVI 3 ()3D video signal(120 Hz)() : DVI is supported only by ZRCT-100.(60 Hz)(60 Hz) 3D sync signal (120 Hz)3D video signal (120 Hz)3D SYNC OUTL1 R1 L60 R60R1 R60L1 L60Emitter