Sony ZRD-1 Installation Manual

Also see for ZRCT-100: Operating instructions Operating instructions

6-35 (E)ZRD-1/ZRD-2/ZRCT-100/ZRCT-2006-12. Data Backup of Display ControllerThe setting data of the display controller is saved (backed up) as a profile in Display Control Software.When the setting data is changed, the data is backed up automatically. The backup data is updated only forthe changed data.The setting data of the display controller saved as a profile in Display Control Software is as follows.Menu (Screen) ItemsController Connection Settings Connection Type (LAN/SERIAL)Primary (On/Off)IP Address/COM PortID(*), Total(*)Unit Layout Settings Display Unit Allocation (display unit layout address of each display unit) (Example:(1,2) and (C1-1-2))Picture Allocation Number (picture starting point of each display unit) (Example: 7(0,360))System Settings Fan ModePhoto Mode (Reserved)Direct Array Power OnLight Output (Version earlier than 1.20.0)Display Unit Power On DelayInput Settings Input SelectOutput Start PositionHigh Frame Rate ModeSingle Stream Mode (Version 1.22.0 or later)Dynamic Range (HDMI Signal Format (Version 1.20.0 or later)Picture Settings Contrast, Brightness, Gamma, Color Space, Color Temperature SettingPicture Mode, HDR, Light Output (Version 1.20.0 or later)3D Settings (Except for S/N2000001 to 2000100 ofZRCT-100 SY model)2D/3D (Version 1.22.0 or later)3D Dual Input Mode (On/Off)3D Dual Input 4K Mode (On/Off)3D Sync Signal Invert Mode (On/Off)3D Sync Signal Delay(*): These items are not displayed on Controller Connection Settings screen.To back up the data manually1. Display the Main screen.2. On the menu bar, click [Tool], and then click [Back Up Controller Data].The following dialog is displayed.