Siemens Sinumerik 840D sl Diagnostic Manual

Also see for SINAMICS S120: Engineering manual Function manual Engineering manual Manual Function manual

NCK alarms03/2009 Overview of Alarms2-111© Siemens AG, 2009. All Rights ReservedSINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/200910770 [Channel %1: ] Block %2 change of corner type due to change oforientation with active tool radius compensationParameters: %1 = Channel number%2 = Block number, labelDefinitions: The type of a corner (inside or outside corner) depends not only on the programmed path but also onthe tool orientation. For this purpose, the programmed path is projected in the plane perpendicularlyto the actual tool orientation and the corner type is determined there. If a change in orientation is pro-grammed (in one or several blocks) between two traversing blocks, resulting in the type of corner atthe end of the first traversing block being different from that at the start point of the second block, theabove error message is issued.Reaction: Correction block is reorganized.Local alarm reaction.Interface signals are set.Alarm display.NC Stop on alarm at block end.Remedy: Modify part program.Program Con-tinuation:Clear alarm with NC START or RESET key and continue the program.10771 [Channel %1: ] Block %2 overflow of local block buffer due to orientationsmoothingParameters: %1 = Channel number%2 = Block number, labelDefinitions: This error occurs when more blocks must be buffered than memory space is available.This error can only occur when the software has been incorrectly configured.Reaction: Correction block is reorganized.Local alarm reaction.Interface signals are set.Alarm display.Remedy: Increase size of local buffer area.Program Con-tinuation:Clear alarm with NC START or RESET key and continue the program.10772 [Channel %1: ] Block %2 illegal orientation change when activating ordeactivating 3D face cuttingParameters: %1 = Channel number%2 = Block number, labelDefinitions: In face milling, no intermediate blocks with pure orientation change are allowed between the activationblock and the first correction block or between the last correction block and the deactivation block (3Dtool radius compensation).Reaction: Correction block is reorganized.Local alarm reaction.Interface signals are set.Alarm display.NC Stop on alarm at block end.Remedy: Modify part program.Program Con-tinuation:Clear alarm with NC START or RESET key and continue the program.10773 [Channel %1: ] Illegal tool orientation in block %2 at inside corner withblock %3Parameters: %1 = Channel number%2 = Block number, label%3 = Block number, label