Siemens Sinumerik 840D sl Diagnostic Manual

Also see for SINAMICS S120: Engineering manual Function manual Engineering manual Manual Function manual

03/2009 List of Action Numbers3-1039©Siemens AG 2009 All Rights ReservedSINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009No. 118Definitions: Switching over the desired safety limits (SGE)is always permittedNo. 119Definitions: Stop run, that is the NCK stops automatically at a blockdefined by the OPI.Not permitted if1. Control is not in Automatic.No. 120Definitions: Fast retraction with a single axisNot permitted if:The axis is not controlled by the PLCNo. 121Definitions: Stop fast retraction with a single axisNot permitted if:The axis is not controlled by the PLCand the single axis does not execute a fast retractionNo. 122Definitions: For test purposes only, and only in assert systems.No. 123Definitions: PI _N_STRTLK Set global start disablealways permittedNo. 124Definitions: PI _N_STRTUL Reset global start disablealways permittedNo. 125Definitions: Implicit change to JOG mode at the start of a "JOG motion" in AutomaticSee also $MN_JOG_MODE_MASKNot permitted if:1. A channel has left the mode group on account of an interrupt.2. OverstoringPossible actions:1. Cancel the program with the Reset button or wait until the interrupt has finished.4. Deselect overstoreNo. 126Definitions: Implicit mode change back at the end of a "JOG motion" started in automatic mode.See also $MN_JOG_MODE_MASKNot permitted if:1. A channel has left the mode group on account of an interrupt.2. OverstoringPossible actions:1. Cancel the program with the Reset button or wait until the interrupt has finished.4. Deselect overstoreNo. 127Definitions: Simulation block search is to be started, that means the results of the computation will only be dis-played on the HMI,NO traverse after block search.Not permitted if:1. The NCK channel is not in RESETPossible action:1. Press reset